Demoor 1250-DC-560
Year of Manufacture 1990 Overhaul 1997 - 2007
Control Siemens 820T
Swing diameter over the bed 1250 mm
Turning length max. 1400 mm
(Actual bed length approx. 3500 mm)
Bed type flat bed
Spindle bore c
Bore front 545 mm
Bore back 560 mm
Spindle drive motor rating 73 KW
Spindle speeds 0 ? 300 rpm
Chuck diameter 1000 mm
Chuck type Double end chuck
4-jaws front
4-jaws back
Turret tool positions 4
Turret tool type Sauter
Complete with:
Chip conveyor full length; Sophisticated software for cutting and re-cutting threads at high speeds; Box of tool holders; Box of jaws; Coolant tank and pump; Control on swing pendant arm
RS 232 serial port on control; Lots of guarding; Machine without tailstock.
Condition: good
Electrical and control retrofit was done in 1997; Headstock and spindle bearings checked 7 years ago; Spindle bearings had slight damage; Spindle bearings were fixed at this time;
Machine ran after that without any problems; Z Axis slides (partly) resurfaced to accept LM guides for 1400 mm length; Ballscrew; AC drive motor; Encoder; Work done in 2007
X Axis is a complete new unit; LM guides; Ballscrew; AC drive motor; Encoder; Work done in 2006
Dismantled and in storage (cold, dry storage)