การ ตั้งค่า port RS-232 เครื่อง cnc ทุกรุ่น
How to Backup and Restore ALL Data in your CNC
One of the most common procedures on CNC controls during maintenance is to
backup all of the data possible before working on a CNC system. In this manner,
a maintenance person can easily restore the control to the original state should a
problem be encountered during the maintenance activity.
Series 0 models A/B/C/D
This series of controls is restricted to using the RS-232 interface for all data
backup and restore operations.
Using the RS-232 interface
To Transfer Programs from CNC to PC
From the CNC Side, do the following:
1. Select EDIT mode.
2. Select the PROGRAM screen.
3. Depress I/O key.
4. Prepare the PC to receive file (See appropriate section on ProComm for
receiving a file on the PC).
5. To output an individual program, enter the Letter O and the part program
number OR to output all programs enter ?9999.
To Transfer Program from PC to CNC
From the CNC side, do the following:
1. Select EDIT mode.
2. Select the PROGRAM screen.
3. Depress I/O softkey.
4. Depress READ softkey.
5. Send file from PC (See appropriate section on ProComm for sending from
PC).
To Transfer Parameters from CNC to PC
From the CNC side, do the following:
1. Select EDIT mode.
2. Select the PARAMETER menu.
3. Prepare PC to receive the file (See appropriate section on ProComm
for receiving a file on the PC).
4. Hold down EOB key and simultaneously depress OUTPUT START
key. 15
NOTE:
Failure to press the EOB key and OUTPUT START will result in an incomplete
parameter file being downloaded.
Transfer Parameters from PC to CNC
From the CNC side, do the following:
1. Set Parameter Write Enable (PWE) to 1.
2. Select EDIT mode.
3. Select the PARAMETER menu.
4. Depress INPUT key.
5. Send the parameter file from the PC (See appropriate section on
ProComm for sending from PC).
6. When the transfer is complete, turn CNC OFF and back ON to use the
new parameter set. Also verify that PWE is set to 0.
NOTE:
To upload and download PMC parameters (Diagnostics) and offsets, the
procedures are the same as for the system parameters. The only difference is
that you must be on the CNC Diagnostic Page for transferring PMC parameters
and the Offset Page for transferring offsets. 16
Series 16/18/21 models A/B/C, Power
คู่มือฉบับเต็ม ทุกรุ่น ของ fanuc control
http://www.siamcncmachinery.com/GE%20Fanuc%200-15-16-18-21%20All%20Version%20Backup%20Manual.pdf
:)